DESCRIPTION
Pump is designed for the transfer of diesel oil. Handy shape, solid workmanship and small size make our pump practical, durable and easy to use. Specifications: Rated voltage: 12V. Rated power: 175W. Throughput: 45L / min. Diam. of inlet and outlet hose connections: 25mm. Maximum liquid column height: 10m. Maximum suction: 5 m. Engine speed: 3600R. Permitted fluids:
Diesel.
Forbidden liquids:
Liquids containing water,
Liquids intended for human consumption.
Important safety rules:
Never move the pump while it is running for any reason.
Before using the pump, always make sure that the power cord and all other accessories are in perfect working order.
Never use the pump without shoes, with wet hands or while standing even partially in the water.
Never remove any part of the housing while the pump is running.
Make sure that the pump source is protected against moisture and water splashes.
Never smoke in the vicinity of the pump.
Never use the pump near an open flame.
Never start the pump before connecting the drain and suction hoses.
Do not use for the transfer of liquids with a density greater than that of diesel fuel. Otherwise there is a great risk of overheating.
Never start the pump before connecting the suction and discharge pipes
Use: To ensure safe and efficient operation of the device, it is essential to comply with all of the following notes:
Be sure to disconnect power to the pump before servicing or cleaning.
To prevent foreign material from being transferred into the tank, install a filter suitable for the type of diesel fuel at the pump outlet.
The tank or barrel should be attached to the ground.
Electrical connection: Before use, make sure that the power source is suitable for powering the pump - 12V. Then proceed as follows:
Connect the pump terminals to a battery capable of providing the current and voltage required to operate the pumps.
If a motor vehicle battery is used to power the pump, we recommend that you first remove it from the vehicle and place it on a firm surface in a comfortable position.
The pump may be connected to the battery installed in the motor vehicle only when it is parked outside and when the electric cables of the pump and hoses are long enough to provide the pump with suitable operating conditions.
The use of extension cords for electric cables connected to the terminals is prohibited. If the supplied cables are not long enough to power the pump, the terminals may only be replaced by appropriately sized plugs by a specialized electrician.
The pump can be connected to a charger with appropriate power and clamps. Never connect the pump terminals directly to the charger terminals - it may cause a spark and, consequently, a fire.
Always respect the polarity: connect the black terminals to the "-" pole and the red terminals to the "+" pole.
We recommend that you first connect the "-" pole and then the "+" pole - this will avoid spark formation and the consequent risk of fire.
Start-up: Before starting the pump, make sure that all cables and hoses are properly connected and sealed. Then place the suction hose in the tank and start the pump IMPORTANT! The operating time of the pump should not exceed 30 minutes . After this time, be sure to turn off Device and allow it to cool down completely before restarting it. IMPORTANT! Never leave the pump's workplace! Control the level of the pumped liquid in the tank!
